42_ using the DVR
using the DVR
SETTING THE DEVICE
You can setup Camera, Storage Device, Remote Device, POS Device and Monitor.
Camera
Setting the Camera
You can set Video, Audio, Channel Name and Dwell Time of a Camera.
Using the mouse may help easy setup.
Press the [MENU] button on the remote control or front
panel.
Use the left/right button (
◄ ►
) to select <Device>.
Device setting menu is selected.
Use the up/down buttons (
▲▼
) to move to <Camera>,
and press [ENTER] button.
Select <Camera>.
A window for setting Video, Audio, Channel Name and
Dwell Time of a Camera appears.
Use direction buttons (
▲▼◄ ►
) to move to a desired
item, and set the value.
Video
- <ON/OFF> : You can turn ON/OFF the selected
channel’s camera.
- <Covert1> : Shows information other than the video of
the selected channel.
For privacy protection, it does not display the video while the recording continues.
- <Covert2> : Shows nothing but an empty screen while the recording continues.
Audio
- If set to <ON>, you can turn the audio of the channel ON/OFF on the Live screen.
- If set to <OFF>, the channel’s audio is off on the Live screen and not recorded.
The audio input is available for CH 1, 2, 3, and 4 only while output allows only one channel.
CH Name : Up to 15 characters including blanks are allowed.
Refer to “Using Virtual Keyboard”. (Page 36)
SEQ-Dwell Time: You can set the dwell time between channels for the Live screen and Spot Out.
If set to <OFF>, the channel is not listed in the Auto Sequence mode.
1.
2.
3.
4.
5.
•
•
•
•
Device
Logout
Exit
Camera
Storage Device
Remote Device
POS Device
Monitor
CH Video
Audio
CH Name SEQ-Dwell Time
1 ON
OFF
CAM 01 5 sec
2 ON
OFF
CAM 02 5 sec
3 ON
OFF
CAM 03 5 sec
4 ON
OFF
CAM 04 5 sec
5 ON
OFF CAM 05 5 sec
6 ON
OFF CAM 06 5 sec
7 ON
OFF CAM 07 5 sec
8 ON
OFF CAM 08 5 sec
Camera
Camera
PTZ
Previous/Next Page
Screen Setup
OK Cancel
To Next Page
Loading...
