This function will reduce the energy usage while the air conditioner is operating in Cool/Heat mode.
When the air conditioner is operating in Cool/Heat mode;
Remote controller display
1. Press the Options button.
2. Press the
, or Options button until (Single user) indicator starts to blink.
3. Press the SET button to set the Single user function.
- (Single user) (Single user) indicator will be displayed on the remote controller
display. Then
will be displayed on the set temperature indicator
part for few seconds and Single user function will begin.
- When the Single user function is on, vertical air swing will turn on automatically.
4. If the current set temperature is lower than 76°F(24°C) in Cool mode, it will be
automatically raised to 76°F(24°C).
Cancel
f Press the Options button Press the , or Options button to
make the (Single user) indicator blink and press the SET button.
t Single user function is only available in Cool/Heat mode.
t If the Single user function is selected while 2-Step Cooling/Fast/
Comfort /Quiet/
function is on, corresponding function
will be cancelled.
t Vertical air swing will remain on even after the Single user function is
cancelled.
Additional options available in Single user function
You can adjust the set temperature by 1 °F within the range of
76°F~86°F (24°C~30°C)
in Cool mode and
61°F~86°F (16°C~30°C)
in Heat mode.
(Auto), (Low), (Med), (High), (Turbo) can be selected.
Vertical/Horizontal air swing can be selected.
Using the Single user function
English-22
To Next Page
Loading...
