English-54
Smart Install mode
This model supports Smart Install mode which checks installation status to nd out if there is any problems with any of the
functions. Execute Smart Install mode after installation.
1. Check the installation of the air conditioner.
1) Check the power supply, service valve (if it's open), power cable of the indoor and outdoor unit and amount of
additional refrigerant required for pipe extension.
2) Status of the indicator after supplying the power : Standby state
2. When the air conditioner is in standby state, use the remote controller to start the Smart Install mode.
1) Press the Set, Mode and Power
button simultaneously for 4 seconds.
N Remote controller may be dierent (image/functions) depending on the model.
To Next Page
Loading...
