Samsung Smart Whisper AR KS Series - Changing Drain Connection

Drain hose
Extension
drain hose
Drain hose
Extension
drain hose
1.57~1.77 inch
(
40~45 mm)
Foam Insulation
0.79inch
(20mm)
or more
0.79inch
(20mm)
or more
Vinyl Tape
Changing drain connection
t 5IFIPTFXJMMCFöYFEQFSNBOFOUMZJOUPQPTJUJPOBGUFSöOJTIJOHUIFJOTUBMMBUJPOBOEUIFHBTMFBLUFTU
refer to page 53 for further details.
t .BLFTVSFUIFJOTUBMMFEEJSFDUJPOPGUIFESBJOIPTFJTDPSSFDU
Inadequate installation may cause condensate water leakage.
t *GUIFESBJOIPTFJTSPVUFEJOTJEFUIFSPPNJOTVMBUFUIFIPTFTPUIBUESJQQJOHDPOEFOTBUJPOEPFTOPUEBNBHFUIF
furniture or oors.
t %0/058"--615)&%3"*/)04&$0//&$5*0/
Drain hose connection must be easy accessible and serviceable.
t .BLFTVSFUIFJOEPPSVOJUJTJOVQSJHIUQPTJUJPOXIFOZPVQPVSXBUFSUPDIFDLGPSMFBLBHF
Make sure that the water does not overow onto the electrical part.
Pour the water in direction of arrow.
KDirection of condensate ow
6. Pass the drain hose under the refrigerant pipe, keeping the drain hose tight.
7. Pass the drain hose through the hole in the wall. Check if it slants
downwards as seen in the picture.
8. Using natural drainage method, check the drainage is normal.
Shield
Drain hose Extension drain hose
Change the direction only when it is necessary.
1. Detach the rubber cap with the pliers.
2. Detach the drain hose by pulling it and turning to the right.
3. Insert the drain hose by xing it with the screw into the groove of the drain
hose and the outlet of the drain pan.
4. Attach the rubber cap with a screwdriver by turning it to the left until it
xes to the end of the groove.
5. Check for leakage on both side of the drain outlet.
Rubber cap
Drain pan outlet
Drain hose
Screw hole
Screw
Installing and connecting the condensate drain hose to indoor unit
English-48