Samsung Smart Whisper AR KS Series - Setting the Display Option; Using the Smart A;C Application

You can conveniently control your air conditioner anywhere with Smart APP.
WIFI is not seen to new remote control LCD.( It is hidden function .)
Remote controller display
1. Press the Timer button to set the WiFi function.
- Press the Timer button for 4 seconds.
-(
) will blink rst, then( ) appears on the remote controller display for few
seconds and disappears. WiFi function will begin.
t 'PSEFUBJMJOGPSNBUJPOQMFBTFSFGFSUP4NBSU"$BQQMJDBUJPONBOVBM
t 4NBSU"$BQQMJDBUJPONBZOPUCFBWBJMBCMFGPSTPNFNPEFMT
Using the Smart A/C application
Setting the Display option
Display lighting can be adjusted by following this instruction.
1. Press the Settings button.
2. Press the
, or Settings button until (Display) indicator starts to blink.
3. Press the SET button to set the display status.
- 3 seconds after setting Display function, (Display) indicator on the remote
controller display will disappear and indoor unit display will be turned o.
Cancel
f Press the Settings button  Press the , or Settings button to
make (Display) indicator blink and press the SET button.
f (Display) indicator on the remote controller display will disappear and
the indoor unit display will be turned on again.
t Display option cannot be set when the air conditioner is o.
t Operation or timer display will not be turned o by the display o function.
English-26