Samsung SMT-i3100 - Call Transfer

26
_ © SAMSUNG Electronics Co., Ltd.
Call Transfer
This is the function used to transfer a call to another person.
1
To transfer a current call to another person, press
the [Transfer] button in the busy state.
2
When a dial tone is heard, press the phone
number of the target person.
- If the target number is a station line number, press the
line directory number and then dial a phone number;
or if it is an extension number, only dial the extension
number.
- In general the station line's directory number is set to
[9] or [0]. For the precise number, consult the system
administrator.
3
When a ringback tone is heard from the target
person, put down the handset.
- Alternately, wait until the target person receives the
call, and then hang up the phone after telling him/her
about it.
The following events may occur when a call is transferred to a target person:
- When the target person does not receive the call:
Press the [Transfer] button again to resume the previous call.
- When the target person is busy:
Press the [Transfer] button again to resume the previous call.
Or, select [RETURN] from the soft menu and wait until the target person finishes
his/her call.
- When an extension line subscriber does not receive the call transferred from a station
line:
By default, if there is no answer in 20 seconds, the call is delivered back to the person
who transferred it. (The elapsed time may differ per system setting.)