English _75
● SETUP SCREEN
Time schedule
You can configure so that an event will occur at a scheduled time regardless of the actual
occurrence of the event.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Time schedule>.
To set the timer event
1. Set <Timer event setup> to <Enable>.
2. Specify the <Activation time>.
• Always : Always activates in operated
mode at the set interval.
• Only scheduled time : Periodically
activates in operated mode at a
specified time and date.
3. Specify the <Transfer interval>.
4. Specify the activation conditions.
• FTP sending : Specify the use of the FTP transfer if an event occurs.
• Record : Specify the use of recording if an event occurs.
5. When done, click [Apply (
)].
Network disconnect
You can perform the saving/relay/preset operation after receiving an event of a physically
disconnected network.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Network Disconnect>.
3. Specify the use of “Network
disconnect”.
4. Specify the activation time and
activation condition.
For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 66)
5. When done, click [Apply (
)].
To Next Page
Loading...
