J
James AndersonSep 12, 2025
What to do if I couldn’t see any threshold rule or area coefficient rule on the monitoring screen of Samsung Security Camera?
- LLindsey WatsonSep 12, 2025
Check if you have set to in - .
To Next PageTo Next PageWhat to do if I couldn’t see any threshold rule or area coefficient rule on the monitoring screen of Samsung Security Camera?
Check if you have set to in - .
What to do if I cannot connect to Samsung SNC-B2331(P) using tab browser in Internet Explorer 7.0?
If you cannot connect to the system using a tab browser of Internet Explorer 7.0, open a new browser window instead of using a tab browser to connect to the system.
Why can't I access my Samsung Security Camera from a web browser?
There could be a few reasons why you can't access your Samsung Security Camera from a web browser. Here are some things to check: * Ensure the camera’s network settings are correct. * Verify all network cables are properly connected. * If using DHCP, confirm the camera obtains dynamic IP addresses without issues. * If using a DDNS URL, double-check that the MAC address is entered correctly. * If the camera is connected to a router, ensure port forwarding is configured properly.
What to do if my Samsung Security Camera connected to the network is not detected in the IP installer program?
If your Samsung Security Camera connected to the network is not detected in the IP installer program, try turning off the firewall settings on your PC and then search for the camera again.
What to do if viewer got disconnected during monitoring Samsung Security Camera?
If your viewer gets disconnected while monitoring with your Samsung Security Camera, it could be due to a few reasons. Check all network connections. Also, if the camera is connected over an xDSL network, disconnections can occur under poor network conditions. Note that any change to camera or network configurations may cause connected Viewers to disconnect.
Why is my SD memory indicator not turning on even when the SD memory card is inserted in Samsung SNC-B2331(P)?
If the SD memory indicator on your Samsung Security Camera isn't turning on even after inserting the SD memory card, check the following: * Verify that the memory card is not defective. * Make sure that the option is checked in the ? ? menu.
Why Samsung Security Camera images overlap?
If images overlap on your Samsung Security Camera, check whether two or more cameras are set to a single multicast address instead of different addresses.
What to do if Samsung Security Camera viewer gets disconnected during monitoring?
If your Samsung Security Camera viewer disconnects during monitoring, start by checking all network connections. If the camera uses an xDSL network, disconnections can occur under poor network conditions.
What to do if I have set to in , but the green box on the monitoring screen is displayed bigger or smaller than the image size of the passer-by on Samsung SNC-B2331(P) Security Camera?
Change the object size as appropriate in - on the monitoring screen and check if the green box fits.
What to do if I cannot connect to the Samsung Security Camera system using a tab browser of Internet Explorer 7.0?
Instead of using a tab browser, open a new browser window to connect to the Samsung Security Camera system.
General| Effective Pixels | 752 (H) x 582 (V) |
|---|---|
| Day/Night | Yes |
| Back Light Compensation | Yes |
| Sensor Type | CCD |
| Image Sensor | 1/3" CCD |
| Min. Illumination | 0.05 Lux (F1.2, 50IRE) |
| Power Source | 12V DC |
| Operating Temperature | -10°C to +50°C |
| Lens Type | Fixed |
| Video Output | CVBS : 1.0 Vp-p / 75 Ohms composite |
