To Next PageTo Next PageWhat to do if SD memory card is inserted but the Samsung SNC-B2331(P) Security Camera does not operate properly?
If your Samsung Security Camera isn't operating properly after inserting an SD memory card: * Check that the memory card is inserted in the correct direction. * Format the memory card again in the ? ? menu. The operation of memory cards formatted by other devices is not guaranteed with this camera unit.
What to do if images overlap on my Samsung SNC-B2331(P)?
If images overlap on your Samsung Security Camera, check whether two or more cameras are set to a single multicast address instead of different addresses. If a single address is used for multiple cameras, the images may overlap.
Why is my SD memory indicator not turning on even when the SD memory card is inserted in Samsung SNC-B2331(P)?
If the SD memory indicator on your Samsung Security Camera isn't turning on even after inserting the SD memory card, check the following: * Verify that the memory card is not defective. * Make sure that the option is checked in the ? ? menu.
What to do if viewer got disconnected during monitoring Samsung Security Camera?
If your viewer gets disconnected while monitoring with your Samsung Security Camera, it could be due to a few reasons. Check all network connections. Also, if the camera is connected over an xDSL network, disconnections can occur under poor network conditions. Note that any change to camera or network configurations may cause connected Viewers to disconnect.
What to do if my Samsung Security Camera connected to the network is not detected in the IP installer program?
If your Samsung Security Camera connected to the network is not detected in the IP installer program, try turning off the firewall settings on your PC and then search for the camera again.
Why can't I access my Samsung Security Camera from a web browser?
There could be a few reasons why you can't access your Samsung Security Camera from a web browser. Here are some things to check: * Ensure the camera’s network settings are correct. * Verify all network cables are properly connected. * If using DHCP, confirm the camera obtains dynamic IP addresses without issues. * If using a DDNS URL, double-check that the MAC address is entered correctly. * If the camera is connected to a router, ensure port forwarding is configured properly.
What to do if I cannot connect to Samsung SNC-B2331(P) using tab browser in Internet Explorer 7.0?
If you cannot connect to the system using a tab browser of Internet Explorer 7.0, open a new browser window instead of using a tab browser to connect to the system.
General| Effective Pixels | 752 (H) x 582 (V) |
|---|---|
| Day/Night | Yes |
| Back Light Compensation | Yes |
| Sensor Type | CCD |
| Image Sensor | 1/3" CCD |
| Min. Illumination | 0.05 Lux (F1.2, 50IRE) |
| Power Source | 12V DC |
| Operating Temperature | -10°C to +50°C |
| Lens Type | Fixed |
| Video Output | CVBS : 1.0 Vp-p / 75 Ohms composite |
