Why can't I access my Samsung SNF-8010 Security Camera from a web browser?
If you are unable to access the camera from a web browser, verify that the camera’s Network settings are correct. Also, ensure all network cables are properly connected. If you're using DHCP, confirm the camera can obtain dynamic IP addresses without issues. If the camera is connected to a Broadband Router, ensure port forwarding is correctly set up.
What to do if my Samsung SNF-8010 viewer got disconnected during monitoring?
If connected viewers are disconnected during monitoring, it might be caused by changes to camera or network configurations. Also, ensure all network connections are secure. If the camera is connected over a PPPoE network, disconnections can occur under poor network conditions.
Why is my Samsung SNF-8010 Security Camera not detected in the IP installer program?
If the camera connected to the network is not detected in the IP installer program, turn off the firewall settings on your PC and then search for the camera again.
What to do if my Samsung Security Camera images overlap?
If images overlap, check whether two or more cameras are set to a single multicast address instead of different addresses. If a single address is used for multiple cameras, the images may overlap.
What to do if my Samsung SNF-8010 Security Camera micro SD memory card is inserted but the camera does not operate properly?
If the memory card is inserted but the camera does not operate properly: * Verify the memory card is inserted in the proper direction. * Note that the operation of a memory card formatted by other devices is not guaranteed with this camera unit. * Try formatting the memory card again in the camera's menu under Setup > Event > Storage.
Why does my Samsung SNF-8010 report that NAS setting has failed?
If the NAS setting has failed, confirm the following: * The IP address, ID, and password of the NAS are valid. * You can access the default folder using the NAS ID. * NAS SMB/CIFS items are unchecked. * The NAS IP address and the camera IP address are in the same format. * You haven't tried to access as another user without formatting the default folder. * You are using recommended NAS equipment.
How to fix no signal at the Alarm Output port on my Samsung SNF-8010?
If no signal is found at the Alarm Output port even when an intelligent video analysis event is generated, check the alarm output port settings.
Why is my Samsung SNF-8010 not sending notification e-mails for motion detection?
If motion detection is enabled but you're not receiving notification emails, verify these settings in sequence: 1. Check the Data & Time settings. 2. Ensure Motion detection is enabled. 3. Confirm the E-mail option of the Event setup menu is checked.
What to do if I cannot connect to my Samsung SNF-8010 using a tab browser of Internet Explorer 7.0?
If you cannot connect to the system using a tab browser of Internet Explorer 7.0, do not use a new window or tab, select 'File ? New session'. An error may be generated when connecting with a new window or tab since the cookie data are shared.
General| Brand | Samsung |
|---|---|
| Model | SNF-8010 |
| Category | Security Camera |
| Language | English |
Key safety precautions to follow before installing and using the product.
Highlights the key functionalities and capabilities of the network camera.
Step-by-step guide for physically installing the camera, including precautions.
Connecting the camera to LAN, DSL, PPPoE, and broadband routers.
Procedures for configuring static and dynamic IP addresses for the camera.
Guide to setting up port forwarding on routers for remote access.
Steps to connect to the camera using a web browser, including IP and URL methods.
Guide for installing the necessary WebViewer plugin for real-time video access.
Explanation of the live viewing screen interface and its controls.
To Next Page