To Next PageTo Next PageSamsung SNV-6013 motion detection is enabled, but no notification e-mail reaches me, what to do?
Verify the settings in the following sequence: 1. Check settings. 2. The should be set to . 3. Check if the option of menu is checked to use.
What to do if Samsung Security Camera viewer got disconnected during monitoring?
If your Samsung Security Camera viewer gets disconnected during monitoring, start by checking all network connections. The disconnection may occur because connected viewers become disconnected upon any change to camera or network configurations. Also, if the camera is connected over a PPPoE network, viewer disconnection can occur under poor network conditions.
Why does my Samsung Security Camera report that NAS setting has failed?
If your Samsung Security Camera reports that the NAS setting has failed, confirm that the IP address and ID/password of the NAS are valid. Also, verify that you can access the default folder using the NAS ID and that the NAS SMB/CIFS items are unchecked. Ensure that the NAS IP address and the camera IP address are in the same format. Finally, check whether you tried to access as another user without formatting the default folder saved or used and confirm that you used recommended NAS equipment.
Samsung SNV-6013: camera connected to the network is not detected in the IP installer program, what to do?
If the camera connected to the network is not detected in the IP installer program for your Samsung Security Camera, turn off the firewall settings on your PC and then search for the camera again.
Why Samsung SNV-6013 images overlap?
If images overlap on your Samsung Security Camera, check whether two or more cameras are set to a single multicast address instead of different addresses. If a single address is used for multiple cameras, the images may overlap.
Samsung Security Camera: Micro SD memory card is inserted but the camera does not operate properly, what to do?
If your Micro SD memory card is inserted but the Samsung Security Camera does not operate properly, check if the memory card is inserted in the proper direction. Operation of a memory card that is formatted by other devices is not guaranteed with this camera unit. Also, format the memory card again in the ? ? menu.
Samsung Security Camera: cannot connect to the system using a tab browser of Internet Explorer 7.0, what to do?
To resolve the issue of not being able to connect to the system using a tab browser of Internet Explorer 7.0 with your Samsung Security Camera, do not use a new window or tab, select “File ? New session.” An error may be generated when connecting with a new window or tab since the cookie data are shared.
General| Category | Security Camera |
|---|---|
| Model | SNV-6013 |
| Image Sensor | 1/2.8" CMOS |
| Max. Resolution | 1920 x 1080 |
| Lens Type | Fixed |
| Focal Length | 3.6mm |
| Aperture Ratio | F2.0 |
| Wide Dynamic Range | 120dB |
| Video Compression | H.264, MJPEG |
| Audio In | Built-in microphone |
| Ethernet | RJ-45 (10/100BASE-T) |
| Power Consumption | Max. 6.5W |
| Ingress Protection | IP66 |
| Min. Illumination | B/W: 0 Lux (IR LED on) |
| Day & Night | ICR |
| Digital Noise Reduction | SSNRIII |
| Frame Rate | 30fps @ 1080p |
| Audio Compression | G.711, G.726 |
| Power | PoE (IEEE802.3af) |
