English _31
● OVERVIEW
Item Description
a
Lens Lens for the camera.
b
Illumination Sensor Detects incoming light to control the IR LED.
c
IR LED These infrared LED’s are controlled by the illumination sensor.
d
Zoom control lever
T Zoom in (Tele)
W Zoom out (Wide)
By rotating it to the right or the left, the lens zoom can be adjusted. By
rotating it clockwise, the zoom can be fixed.
e
Focus control lever
N Focusing on a near object (Near)
F Focusing on a far object (Far)
By rotating it to the right or the left, the focus can be controlled. By rotating it
clockwise, the focus can be fixed.
f
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
g
Micro SD Memory
Card Compartment
Compartment for the Micro SD memory card.
h
Audio input terminal Terminal to connect to audio cables.
i
PoE Connector Connects to the network and supplies power through Ethernet cable.
To Next Page
Loading...
