Samsung SP0802N - Standards and Regulations; Hardware Requirements

DESCRIPTION
SpinPoint P80 Product Manual Rev. 01 5
•
Supports both CHS and LBA Addressing modes
• Supports all logical geometries as programmed by the host
• 2MB/8MB buffer memory for read and write cache.
•
Transparent media defect mapping
• High performance in-line defective sector skipping
• Auto-reassignment
•
Automatic error correction and retries
• On-the-fly (OTF) error correction
• Noise predictive PRML read channel
•
TA detection and correction
• Dynamic anti-stiction algorithm
• Advanced GMR head
•
SMART III support
• Cable select ability
• Support Automatic Acoustic Management (AAM)
2.3 Standards and Regulations
The SpinPoint P80 depends upon its host equipment to provide power and appropriate environmental
conditions to achieve optimum performance and compliance with applicable industry and governmental
regulations. Special attention has been given in the areas of safety, power distribution, shielding, audible
noise control, and temperature regulation.
The SpinPoint P80 hard disk drives satisfy the following standards and regulations:
• Underwriters Laboratory (UL): Standard 1950. Information technology equipment including business
equipment.
• Canadian Standards Association (CSA): Standard C22.2 No.3000-201 Information technology
equipment including business equipment.
•
Technisher Überwachungs Verein (TUV): Standard EN 60 950. Information technology equipment
including business equipment.
2.4 Hardware Requirements
SpinPoint P80 hard disk drives are designed for use with host computers and controllers that are PC/AT
compatible. They are connected to a PC either by:
• Using an adapter board, or
•
Plugging a cable from the drive directly into a PC motherboard with an IDE (Integrated Drive
Electronics) interface.