Samsung SP0802N - Table 6-18 Command Errors

DISK DRIVE OPERATION
SpinPoint P80 Product Manual Rev. 01
84
Table 6-18 Command Errors
Error Register Status Register
Command
BBK UNC IDNF ABRT TK0NF AMNF DRDY DWF DSC CORR ERR
Check Power Mode V V V V V
Download Micro Code V V V V V
Execute Drive Diags V
Flush Cache V V V V V
Format Track V V V V V V
Identify Drive V V V V V
Idle V V V V V
Idle Immediate V V V V V
Initialize Drive Parms V V V
Read Buffer V V V V V
Read DMA V V V V V V V V V V
Read Long V V V V V V V V
Read Multiple V V V V V V V V V V
Read Native Max Addr. V V V V
Read Sector(s) V V V V V V V V V V
Read Verify Sector(s) V V V V V V V V V V
Recalibrate V V V V V V
Seek V V V V V V
Set Features V V V V V
Set Max Address V V V V
Set Multiple Mode V V V V V
Sleep V V V V V
SMART command V V V V V
Standby V V V V V
Standby Immediate V V V V V
Write Buffer V V V V V
Write DMA V V V V V V V
Write Long V V V V V V V
Write Multiple V V V V V V V
Write Sector(s) V V V V V V V
Invalid Command V V V V V
Legend:
V = Valid on this command AMNF = Data address mark not found
BBK = Bad block detected DRDY = Drive not ready detected
UNC = Uncorrectable data error DWF = Drive write fault detected
IDNF = Requested ID not found DSC = Disk seek complete not detected
ABRT = Abort command error CORR = Corrected data error
TK0NF = Track zero not found error ERR = Error bit in the Status register