Samsung SP0802N - Page 70

DISK DRIVE OPERATION
SpinPoint P80 Product Manual Rev. 01
62
Table 6-7 IDENTIFY DEVICE information (continued)
Word Content Description
Command set/feature enabled. . (The default manufacturing setting is as below)
15-14 Reserved
13 1=Flush Cache Ext supported
12 1=Flush Cache supported
11 1=Device Configuration Overlay features supported
10 1=48 bit address feature supported
9 1-Automatic Acoustic feature enabled
8 1=Set Max Security feature enabled by Set Max Set Password
7 1=Set Address Offset Reserved Area Boot, INCITS TR27:2001
6 1= Set Features subcommand required to spin-up after power-up.
5 1=Power up standby feature set enabled
4 1=Removable media status notification feature set enabled
3 1=Advanced Power Management feature set enabled
2 1=CFA feature set enabled
1 1=READ/WRITE DMA QUEUED supported
86 0001h
0 1=DOWNLOAD MICROCODE command supported
Command set/feature default.
15 Shall be set to 0
14 Shall be set to 1
13-8 Reserved
7 1=Write DMA Queued FUA Ext command supported
6 1=Write DMA FUA Ext and Write Multiple FUA Ext command supported
5 General purpose logging feature set supported
4 1=Valid Configure Stream command has been executed
3 1=Media Card Pass Through command feature set enabled
2 1=Media serial number is valid
1 1=SMART self-test supported
87 4003h
0 1=SMART error logging supported
Ultra DMA transfer modes
15-8 (=0Xh) Current active Ultra DMA transfer mode
15 Reserved (=0)
14 Ultra DMA mode 6 1= Active 0= Not Active
13 Ultra DMA mode 5 1= Active 0= Not Active
12 Ultra DMA mode 4 1= Active 0= Not Active
11 Ultra DMA mode 3 1= Active 0= Not Active
10 Ultra DMA mode 2 1= Active 0= Not Active
9 Ultra DMA mode 1 1= Active 0= Not Active
8 Ultra DMA mode 0 1= Active 0= Not Active
7-0 (1Fh) Ultra DMA transfer mode supported
7 Reserved (=0)
6 Ultra DMA mode 6 1= Support
5 Ultra DMA mode 5 1= Support
4 Ultra DMA mode 4 1= Support
3 Ultra DMA mode 3 1= Support
2 Ultra DMA mode 2 1= Support
1 Ultra DMA mode 1 1= Support
88 001Fh
0 Ultra DMA mode 0 1= Support
89 XXXXh Time required for Security Erase Unit completion
90 XXXXh Time required for Enhanced Security Erase completion
91 XXXXh Current Advanced Power Management value
92 XXXXh Master Password revision code
93 4101h Hardware reset result. The contents of bits 12-0 of this word shall change only during the
execution of a hardware reset.