Samsung SRD-894 - Page 75

English _75
● MAIN MENU
Connecting and Setting the Network
Networking may differ from the connection method, check your environment before setting the connection mode.
When no router is used
• Static mode
- Internet connection : Static PPPoE, leased line, and LAN environments allows connection between the DVR
and remote user.
- DVR Network Settings : Set the <Connection Mode> in
<Interface> menu of the connected DVR to <Static>.
 Consult your network manager for IP Address, Gateway and
Subnet Mask.
• DHCP mode
- Internet connection : Connect the DVR directly to a cable
modem, DHCP PPPoE modem or FTTH network.
- DVR Network Settings : Set the <Connection Mode> in
<Interface> menu of the connected DVR to <DHCP>.
• PPPoE mode
- Internet connection : An PPPoE modem is directly connected to the DVR, where the PPPoE connection
requires user ID and password.
- DVR Network Settings : Set the <Connection Mode> in
<Interface> menu of the connected DVR to <PPPoE>.
 <ID> and <Password> should be the same to the PPPoE user
information.
If you don’t know the ID and password, consult your PPPoE service
provider.
Connection Mode
Interface
Port Alarm
x
IP Type Static
x
Transfer Bandwidth 2Mbps
OK Cancel
x
IP Address 192.168.1.200
x
Gateway 192.168.1.1
x
Subnet Mask 255.255.255.0
x
DNS
Manual 168.126.63.1
Connection Mode
Interface
Port Alarm
x
IP Type PPPoE
x
Transfer Bandwidth 600kbps
OK Cancel
x
IP Address
192.168.1.200
x
Gateway
192.168.1.1
x
Subnet Mask
255.255.255.0
x
DNS Manual 168.126.63.1
x
ID ID
x
Password
************