Network Setting
IP Setting
• Auto
• Manual
- IP Address : Manually enter the IP Address if IP Setting is set to Manual.
- Subnet Mask : Manually enter the Subnet Mask if IP Setting is set to Manual.
- Gateway : Manually enter the Gateway if IP Setting is set to Manual.
MagicInfo
Available Modes
•
PC / DVI / DisplayPort
•
AV
•
Component
•
HDMI
•
MagicInfo
•
TV
Note
• A TV tuner box (sold separately) must be connected to use the TV.
• MagicInfo can only be enabled when a network box is connected.
Note
• The remote control
can be used to select MagicInfo. However, it is recommended to use a separate
USB keyboard to utilize MagicInfo fully.
• For MagicInfo in Device mode, moving external devices while booting may cause errors. Set up
external devices only if the LCD Display turns on.
• Do not unplug the LAN cable used for the network (ex: video display). Otherwise, the program
(MagicInfo) may stop. If you do unplug the cable, restart the system.
• Do not unplug the LAN cable used by an USB device (ex: video display). Otherwise, the program
(MagicInfo) may stop.
Adjusting the LCD Display