Connections 58
– Keep Wi-Fi on during sleep: Specify when to
switch from Wi-Fi to mobile data for data
communications when the device goes to sleep
(when the backlight goes out).
– Always allow scanning: Allow Google location
service and other apps to scan for networks, even
when Wi-Fi is turned off.
– Wi-Fi timer: Set the start and end time to connect to
or disconnect from Wi-Fi networks.
– Install certificates: Install certificates from a
memory card.
– MAC address: View your device’s MAC address
(not configurable).
– IP address: View your device’s IP address
(not configurable).
• WPS push button: Set up a connection to a WPS
(Wi-Fi Protected Setup) router or other equipment.
•WPN PIN entry: View the PIN used by your device to
set up a PIN-secured connection to a Wi-Fi router or
other equipment (not configurable).
•Help
: Learn about setting up and using Wi-Fi networks.
Wi-Fi Direct
Wi-Fi Direct allows devices to connect to each other directly
via Wi-Fi, without a Wi-Fi network or hotspot, and without
having to set up the connection.
Important! All devices must be Wi-Fi Direct-enabled.
Turn Wi-Fi Direct On
1. From a Home screen, touch ➔ Settings ➔
Connections tab ➔ Wi-Fi.
2. Touch the OFF/ON button to turn Wi-Fi ON .
(Wi-Fi must be enabled to use Wi-Fi Direct.)
3. Touch Wi-Fi Direct to turn Wi-Fi Direct on.
Turn Wi-Fi Direct Off
1. From a Home screen, touch ➔ Settings ➔
Connections tab ➔ Wi-Fi.
2. Touch Wi-Fi Direct to view connections.
3. Touch End connection to turn Wi-Fi Direct off and
terminate all Wi-Fi Direct connections
Note: Turning Wi-Fi off also turns off Wi-Fi Direct and
terminates all Wi-Fi Direct connections
To Next Page
Loading...
