33
Eco Saving Plus
The Eco Saving Plus function reduces power consumption by controlling the electric current used by
the monitor panel.
―
This option is not available when
Bright is in Dynamic Contrast mode.
―
This menu is not available when
Game Mode is enabled.
―
This menu is not available when
Eye Saver Mode is enabled.
―
Not available when
PIP/PBP Mode is set to On.
• Off: Deactivate the Eco Saving Plus function.
•
Auto: The power consumption will automatically be reduced by about 10% over the current setting.
(The reduction of power consumption depends on the customer screen brightness condition.)
•
Low: The power consumption will be reduced by 25% over the default setting.
•
High: The power consumption will be reduced by 50% over the default setting.
Off Timer
Off Timer: Turn on Off Timer mode.
Turn Off After: The off timer can be set within a range of 1 to 23 hours. The product will automatically
power off after the specified number of hours.
―
This option is only available when
Off Timer is set to On.
―
For products for the market in some regions, the
Off Timer is set to automatically activate 4 hours after the
product powers on. This is done in accordance with power supply regulations. If you do not want the timer
to activate, go to MENU System and set Off Timer to Off.
PC/AV Mode
Set PC/AV Mode to AV. The picture size will be enlarged.
This option is useful when you view a movie.
• Set to
PC when connected to a PC.
• Set to
AV when connected to an AV device.
―
Supplied for the wide models only such as 16:9 or 16:10.
―
If the monitor (when set to
HDMI 1, HDMI 2 or DisplayPort) is in power saving mode or is displaying the
message Check Signal Cable, press the MENU button to display the On Screen Display(OSD). You can select
PC or AV.
DisplayPort Ver.
Select your Displayport. Displayport 1.1 supports High Bit Rate 1, while 1.2 supports High Bit Rate 2.
―
Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
―
If the monitor (when set to
HDMI 1, HDMI 2 or DisplayPort) is in power saving mode or is displaying the
message Check Signal Cable, press the button to display the On Screen Display (OSD). You can select 1.1
or 1.2.
―
If you select
1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1
transmission speeds.
Source Detection
―
Not available when
PIP/PBP Mode is set to On.
Select either Auto or Manual as the method to recognize input signal.
To Next Page
Loading...
