EasyManua.ls Logo

Samsung WA400 Series - Wash Cycles and Options

Samsung WA400 Series
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting _ 21
4-2. CORRECTIVE ACTIONS FOR EACH ERROR CODE
► Thesearecommontroubleshootingproceduresforeachdrum-typewashererrormode.Fordetailedinformation,refertothegeneralrepairscripts.
Error Type
Error
Mode
Causes Corrective Actions Description of Photo
Display
Water Level
Sensor
• Waterlevelsensorfault
• Incorrectconnectionsofthewater
level sensor terminal
• Thehosepartforthewaterlevel
sensor is folded.
• MainPCBfault
• Checkthewaterlevelsensorterminalconnections
and contacts.
• Anerroroccursifanincorrectwaterlevelsensor
isused.Makesuretocheckthematerialcode.
(Abnormal operation)
• Ifthewaterlevelsensorisfaulty,replaceit.
• Iftheerrorpersistsdespitetakingtheactionabove,
replace the PBA.
► Checkthewaterlevelsensor
frequency.
1. Checkitafterthewaterlevel
sensor and the connector are
connected.
CheckingPart:Blue
Color Wire Oragne Color
Wire
2. Frequency:Approx.26.4KHz
without water (Min 25.9KHz)
Washing Motor
Error and Hall
Sensor Error
· Washing motor fault
· Washing motor hall
sensor fault
· Incorrect connections of
the washing motor/hall
sensor connector
· Washing motor rotor
and stator fault
· Main PCB fault
•Checkthemotorconnectorterminal
connections and contacts.
•3Eisdisplayedbecauseoverloading
occurs due to too much laundry.
•Ifthehallsensorterminalisfaulty,
replace the hall sensor.
•Checkwhetherthestatorofthe
motor cover is damaged.
•Checkforcoildisconnectionsdueto
foreign material.
•IfthePBAcontrolcircuitisfaulty,
replace the PBA.
► CheckthemotorWinding
Coil
•Plugouttheconnectorand
read resistances at any two of
the three terminals on Motor
:Shouldbe19.3Ω(at25
o
C)
CN1
1-5V-1
2-Hall-A
3-Hall-B
4-GND
5-Clutch Hall IC
► CheckthemotorHallSensor
Checktheresistanceonthe
main PCB motor
(Betweenpins2and4,3and4
of the four (4) pins)
-Resistance:Approx.2to4
-Checkthevoltagewhenthe
power is on.
Hudson Washer.indb 21 2012-03-28 �� 9:45:57

Other manuals for Samsung WA400 Series

Related product manuals