Samsung WA45M3100AW/A4 - Standard Disassembly Drawings

10 _ Disassembly and Reassembly
3-2. STANDARD DISASSEMBLY DRAWINGS
► Thisisastandarddisassemblydiagramandmaydifferfromtheactualproduct.
Use this material as a reference when disassembling and reassembling the product.
Part Figure Description
Sub and Main PCB
1. Remove the 6 screws holding the control
panel assembly.
2. Separate the both hooks. (Left and Right)
3. Separate the cover panel upward.
 Ifitisdifculttodisassemble,usethe(-)
driver to disassemble hooks.
(Be careful damage of hooks.)
4. Remove the 2 screws holding the control
panel assembly and turn the panel over.
5. Pull the Encoder-Knob to separate it and
thenremovethe4xingscrews.
When reassembling the PCB, take care
that you do not damage the control-panel
xinghook.AfterreplacingthesubPCB,
check the key operation.
6. Pull and lift up the cover PCB(m).
7. Separate the cover pcb(m) and the wires
connected to the main PBA.
After reassembling the housing, check
if the wires are properly connected.
When disassembling and reassembling
the housing, take care that you do not
damage the part.