12 _ Removal and Reassembly
Part Figure Description
Separating the
Cover-Top and
Panel-Control
(Check Sub-PCB)
1. Remove the 2 hexagon screws, which are at the
back,xingtheCOVER-TOP.
2. Disassemble the COVER-TOP by sliding it
backwards.
3. Press the Separate button to separate the ASSY
DRAWER.
4. Remove the 3 screws in Assy Housing Drawer,
and disassemble Assy Housing Drawer by sliding it
backwards.
5. After remove 4 screws in PANEL-CONTROL, Pull
the PANEL-CONTROL towards and then lift it
upwards to separate.
6. Carefully disconnect the wire connectors by hand.
To Next Page
Loading...
