18 _ Removal and Reassembly
Part Figure Description
Disassembling and
Repairing the Water
Supply Valve
1. Remove the Assy Cover Top.
2. Disconnect the water supply valve wire connector.
3. Remove the 2 screws holding the water supply
valve.
4. Remove the hose connected to the valves.
(Use the plier to remove the hose.)
Disassembling and
Repairing the Water
Level Sensor
1. Separate the wire connected the SENSOR-
PRESSURE.
2. Adjust the plastic clip( of pressure sensor) between
two nose of plier, then grip and pull the plastic clip
with caution. (Use the long nose plier to push the
hook).
3. Remove the hose from the SENSOR-
PRESSURE.
Disassembling the
inside Detergent Box
• Hold the Hose and Nozzle and disassemble from
Diaphragm.
To Next Page
Loading...
