Samsung WW8 K5 Series User Manual

52 English
Troubleshooting
Troubleshooting
Code Action
HC
High temperature heating check
• If the information code remains, contact a customer service
centre.
1C
The Water Level sensor is not working properly.
• Try power off and restarting the cycle.
• Check WaterLevel Sensor wire harness.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the “1C” code, the washer do
draining for 3 minutes. During this time, the Power button is
inoperative.
8C
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
AC
Check communications between main and sub PBAs.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service
centre.
AC6
Check communications between main and inverter PBAs.
• Depending on the state, the machine may automatically returns
to normal operation.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
ddC
This message appears when you open the Add Door without
pressing Pause. If this happens, do one of the following:
• To add laundry, press the Add Door to close it properly. Then,
press Start/Pause and try again.
• If you press the Add Door by mistake, press the Add Door
again to close it properly. Then, press Start/Pause to resume
operation.
If any information code keeps appearing on the screen, contact a local Samsung service
centre.
WW85K5410WW(SA)_DC68-03677B-03(v1)_EN.indd 52 2017/7/5 10:02:08

Samsung WW8 K5 Series Specifications

General

Brand	Samsung
Model	WW8 K5 Series
Category	Washer
Language	English