SAMWONTECH
4st Edition of TEMI2000_Series IM : Aug. 18. 2009 Page 19 / 55
3.3.5 PROGRAM operation STOP Screen
▶ Once the operation has completed normally as all setting on processed pattern, PROGRAM operation
will stop and ‘PATTERM OPERATION END’ message appears show as [Figure3-13]
▶ However, this message will not appear if the operation is stopped by force pressing ‘STOP’ button.
▶ That message will disappear with pressing any part of touch screen.
☞ This also applies to FIX STOP.
Figure 3-13 PROGRAM operation STOP Screen
To Next Page
Loading...
