Samwontech TEMI2500 User Manual

SAMWONTECH
4st Edition of TEMI2000_Series IM : Aug. 18. 2009 Page 49 / 55
▶ [Figure 7-3] and [Figure 7-4] are screens when occurring DI ERROR.
▶ DISPLAY METHOD for DI ERROR occur between TEXT and PICTURE can be set on [11. DI CONFIG]
of the [Instruction Manual].
▶ The (EXIT) button is used to return to the Operation screen.
☞ The
(EXIT) button after DI ERROR occurring makes system ignores same DI ERROR for one
minute.
Ex.)
-The same DI 1 ERROR will be ignored for one minute, even if DI 1 ERROR occurs once again during
that time, by the
(EXIT) button while DI 1 ERROR.
-However, after one minute, DI ERROR screen will be displayed by the same DI 1 ERROR.
※ ‘Ignore’ means the DI ERROR screen is not shown.
▶ The
(BUZ.OFF) button stops the BUZZER SOUND under DI ERROR.
Ex.) This will be explained according to the lamp situation
※ While DI ERROR, the related DI lamp will be ‘ON’ with red. (
(TEXT), (PICTURE))
※ After release the DI ERROE, this lamp will become ‘OFF.’ (
(TEXT), (PICTURE))
[Figure 7-3] DI ERROR screen on TEXT mode
[Figure 7-4] DI ERROR screen on PICTURE mode

Samwontech TEMI2500 Specifications

General

Brand	Samwontech
Model	TEMI2500
Category	Controller
Language	English