S&C Instruction Sheet 461-508LD 9
Software
Downloading Software
The TripSaver II Service Center Configuration Software is available for download
only to customers who have purchased the configuration kit. For each configuration
kit purchased, the user is entitled to install and use TripSaver II Service Center Conguration
Software on no more than two computers at a time. The latest software release is posted on the
S&C Automation Customer Support Portal. A username and password are needed to log in to the
portal. A new S&C customer should complete the form in the lower section of the webpage and a
new username and password will be sent. If a password is already available, click on the Log-In
To Secure Site button. Enter the username and password to log in to the portal. Download the
installer SCC1.9_Installer.exe from the portal.
Installing Software
Double-click the downloaded installer le and follow the on-screen instructions. The installer will
automatically install Microsoft .NET framework onto the computer if the required .NET version is
missing. Administrative privileges are needed to nish the installation.
Launching Software
To launch the software, click on the green SCC 1.9 icon on the desktop or in the Start menu.
A warning screen will be displayed just after the software is launched. Read the message
carefully and understand the warning. Proceed by clicking on the green I have read and
understand the above warning button.
When the software is launched, settings can be configured and saved while in the Standalone
(offline) mode.
To Next Page
Loading...
Need help?
General
