82001-PG-ERR-2.11.doc
7/3/2008
Page 3 of 5
d) A fatal fault on the WX-500 is indicated by a
message ‘FLT’. Please see your authorized
Stormscope dealer for service.
3. Back Course Approach Operation:
When flying a back course approach, the course pointer
should be set to the published front course. In software
versions 2.10 and later, the bottom CDI will
automatically reverse sense when the course pointer is
more than +/-90 Deg from the lubber line. The label
‘BC’ will appear above the bottom CDI during a back
course approach as a reminder to the pilot as shown in
the diagram below.
4. Appendix 2: Selected Course and Current Waypoint,
Bearing & Distance callouts are reversed on page A2-4.
To Next Page
Loading...
