Sandel SN3308 - SN3308 On-screen System Messages

7-3
7
SN3308 On-screen Messages
CHAPTER
Messages
The Sandel SN3308 displays different messages to alert the pilot.
The messages are initiated by the Pilot, the Built In Self Test (BIST),
the Power On Self Test (POST) or by the System. Most of the Pilot
initiated messages are shown on-screen for two seconds and are
removed automatically. Error messages which are considered
critical are places on-screen permanently until acknowledged. The
Acknowledgment is done using the ACK soft-key which will appear
and flash when such a message appears. It also monitors its own
internal temperature and provides warnings for over-temperature
or loss of cooling conditions.
Display Item Source Notes
*OVERTEMP SHUTDOWN* BIST Note 2
+15v OVER VOLTAGE BIST Note 1
+15V UNDER VOLTAGE BIST Note 1
10 MINS TILL OVERTEMP BIST Note 1
-15V OVER VOLTAGE BIST Note 1
-15V UNDER VOLTAGE BIST Note 1
3 DEGREES TO SHUTDOWN BIST Note 2
3v OVER VOLTAGE BIST Note 1
3v UNDER VOLTAGE BIST Note 1
400HZ INVERTER LOSS BIST Loss of main inverter - Note 3
INVERTER FREQ TOO LOW BIST Problem with main inverter - Note 3
INVERTER FREQ TOO HIGH BIST Problem with main inverter - Note 3
5v OVER VOLTAGE BIST Note 1
5v UNDER VOLTAGE BIST Note 1
COOLING FAN FAILURE BIST Note 2