Need help?Do you have a question about the Sandel ST3400 and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Weight | 4.5 lbs (2.04 kg) |
| Power Supply | 28 VDC |
| Certifications | TSO-C113, DO-160F |
| Storage Temperature | -40°C to +70°C |
| Input Voltage | 28 VDC |
| Interfaces | RS-232, RS-422 |
Details the ST3400 TAWS/RMI unit, TAWS technology, modes, and required equipment.
Lists required equipment for Class A/B TAWS and FAA requirements by operation type.
Details technical specs, approvals, dimensions, and interface characteristics.
Outlines TSO stipulations and procedures for installation and operational approval.
Simplifies installation via on-screen setups and lists sensor requirements for Class A/B.
Discusses airdata hookup, altitude sources, OAT requirements, and block diagrams.
Summarizes planning steps and post-installation checks, tests, and verification.
Details power sources, audio outputs, and optional external annunciators.
Covers GPS/FMS, Radar Altimeter, Heading, ADF, NAV/Glideslope, and Air Data interfaces.
Explains traffic input and procedures for uploading equipment data and software.
Details Flaps, Landing Gear, Autopilot, Display Dimming, and Wiper inputs.
Covers unpacking, inspection, cooling, and mechanical mounting considerations.
Outlines electrical installation practices, wiring, grounding, and power.
Details pinouts for Connectors P1, P2, P3, P4 and signal electrical characteristics.
Explains the difference between normal flight mode and maintenance mode.
Accessing maintenance pages, uploading data/software, and configuration module usage.
Explains the Maintenance Index, cursor, soft keys, and modes for navigation.
Details setup for System, Air Data, ADF/HDG, Discretes, NAV/ILS, RADALT, GPS/FMS, TCAS, Status, and Callouts pages.
Covers power-on self-test, unit installation, and recording aircraft/system info.
Lists test equipment and procedures for brightness, audio, power, and software CRC checks.
Tests AIR DATA, ADF, HEADING, DISCRETE, NAV/ILS, RADALT, GPS/FMS, TRAFFIC, and system functions.
Checks display viewability, manual brightness, and pilot accessibility.
Refers to component manual and details database update procedures.
Advises on new software availability and states lamp requires no scheduled maintenance.
To Next Page
