Voice Recording 19
3
This chapter helps you get started recording sound with
your SanDisk Sansa™ m200 Series MP3 Player.
Voice Recording
Your player has a recording mode that can record voice to file. This chapter
helps you to become familiar with the Recorder features.
Using the Recorder Controls
Your player has two modes of operation: Play Music and Recorder. To record
your voice, you need to be in Recorder mode. Follow these steps:
1. Press the Power/Menu Button once. The SanDisk logo and Sansa logo
will briefly appear onscreen then disappear. (Can’t find the Power/Menu
Button on your player? See The Basic Controls section on page 5.)
WARNING: If the onscreen message says „Locked“ and then shuts off,
locate the Hold Button on the left side of your player. Slide that button
up to unlock your device. Then repeat Step 1 above. See The Basic
Controls section on page 5 if you cannot find the Hold Button.
2. If you do not see the Recorder onscreen, briefly press the Power/Menu
Button on the right side of your player. The software Menu will appear.
Press the Repeat/AB/Down Button to scroll and highlight Recorder
mode. Press the Select Button to enter Recorder mode.
When you are in Recorder mode, the screen shown in Figure 5 will appear
on your player.
Figure 5: The Recorder LCD screen
To Next Page
Loading...
