To Next Page

To Previous Page

ENGLISH

9.4.3. Temperature set point adaptation vs. outdoor temperature

Constant supply air T°C with

outdoor T°C compensation

Heating mode

Controller operation is similar to ﬁ rst case. In this case,

main difference is deﬁ ning a compensation curve deﬁ ned

from factory with 8 set points instead of ﬁ xing a single tem-

perature set point.

Compensation curve

The supply set point is then

adapted with respect to this

curve. At any time, from the

main screen you can manu-

ally change the supply tem-

perature (range of +/-3ºC).

9.4.4. Automatic control mode

Depending on the temperatures the controller select the most suitable temperature con-

trol mode, between “Supply temperature control with compensation for outdoor tempe-

rature” and “Room temperature control”.

9.5. INITIAL TEMPERATURE SETPOINT

To set the setpoint temperature to maintain, keep the following secuence:

Once selected the setpoint temperature.

Questions and Answers:

Need help?

Do you have a question about the S&P CADB/T-HE PRO-REG Series and is the answer not in the manual?

S&P CADB/T-HE PRO-REG Series Specifications

General