S&P CADB/T-HE PRO-REG Series User Manual

52
ENGLISH
16.3.5. Controller reconfi guration required to manage external fi lter module FB-CA HE or FBL-HE
17. RESET THE CORRIGO CONTROLLER
In some cases, after several adjustments or due to a bad working, it could be necessary to reset the
controller. After isolating the unit and switching-off the main switch, open the door which gives access
to the electronic board. Remove all the connectors attached to the controller with the exception of the
4-way electrical supply green plug connected to terminals 1,2, Earth and 4.
A 05 95 A 04 94 A 03 93
A 02 92 A 01 91 Agnd 90 DI 8 78
DI 7 77 DI 6 76 DI 5 75 DI 4 74 DI 3 73 DI 2 72
E 63
Ext.
Disp.
N 62
A 61
B 60 E 53
P 1
A 51
B 50
P
2
P 1 Rx
Tx
P 2 Rx
Tx
TCP / IP
P / B
N 52
DI 1 71
TCP / IP
45 UI4
44 UI3 43 Agnd
42 UI2 41 UI1
40 AGND 35 AI4
34 AI3 33 Agnd
32 AI2 31 UI
1
30 Agnd
17 D07
16 D06 15 D05
14 D04
13 D03 12 D02
11 D01
10 GD0 4 +C 2 G0
-
1 G +
TCP / IP
45 UI4
44 UI
3
43 Agnd
42 UI
2
41 UI1 40 AGND
35 AI4
34 AI3
33 Agnd
32 AI2
31 UI1
30 Agnd 17 D07
16 D06
15 D05
14 D04
13 D03
12 D02
11 D01
10 GD0 4 +C 2 G0 - 1
G+
A 05 95
A 04 94
A 03 93 A 02 92
A 01 91
Agnd 90 DI 8 78 DI 7 77
DI 6 76
DI 5 75
DI 4 74
DI 3 73
DI 2 72
E 63
Ext.
Disp.
N 62
A 61
B 60 E 53
P
1
A 51
B 50
P 2
P 1 RxTx P 2 Rx
Tx
T
CP / IP
P / B
N 52
DI 1 71
With a screwdriver, release the controller from the DIN rail on which it is mounted.
To reset the controller, it must be under voltage so re-energise the CADB/T-HE at the isolator and also
on the unit by switching back on the main switch.

S&P CADB/T-HE PRO-REG Series Specifications

General

Brand	S&P
Model	CADB/T-HE PRO-REG Series
Category	Heating System
Language	English