To Next Page

To Previous Page

Activating the Alarm Function

1. To activate the alarm function, repeatedly press the ALARM/SNOOZE button. The

alarm wake-up modes will be displayed and change in the below sequence on every

press:

Alarm Off DAB Preset # FM Preset # Buzzer Tone #

2. When the display shows your desired alarm wake-up mode, stop pressing the ALARM/

SNOOZE button. The alarm function is now activated and an alarm icon will be

displayed.

3. When the alarm time arrives, the selected wake-up mode will be on and the alarm icon

in the display will ash to indicate that the alarm is triggered. To stop the alarm sooner,

press the STANDBY button.

4. To check the alarm status, press the ALARM/SNOOZE button. The alarm status will

show on the display.

• If you have activated the alarm function and the wake-up mode is DAB or FM, make sure that the

volume is at a sucient level for you to hear.

• If the wake-up mode is DAB and the DAB signal strength is low, the buzzer alarm will be triggered.

Automatic Alarm Repeat

The alarm will automatically repeat each day at the selected time as long as the alarm icon

is displayed. To cancel this function, repeatedly press the ALARM/SNOOZE button until

“Alarm O” shows on the display.

Snooze Function

When the alarm has triggered, press the ALARM/SNOOZE button to temporarily switch

o the alarm for 5 minutes. The display will show “z” to indicate that snooze is on. Snooze

function will continue for 1 hour from the set alarm time.

Sleep Function

This function allows you to program the unit to turn to standby mode by itself after a set

period of time.

1. To activate the sleep function, press the SLEEP button repeatedly and the “Sleep

Timer” shows on the display. The time will change in the below sequence on every

press:

90 80 70 60 30 10

2. When your desired sleep time appears in the display, stop pressing the button and the

sleep function will be activated in two seconds. “ ” will be displayed on the display.

3. When the sleep time counts to zero, the unit will turn to standby mode. To put the

sleep function o while the sleep timer is still counting down, press the SLEEP button

once, “ ” will disappear from the display.

4. Press the INFO button repeatedly to show the sleep timer status on the display when

it is turned on.

S2DABB_W11E IB_121121_Michelle.indb 11 21/11/2012 3:37 PM

Sandstrom S2DABB11E User Manual

Questions and Answers: