12
GB
Display Backlight
There are four backlight levels for you to select from in On mode.
To set the backlight, press the BACKLIGHT button repeatedly and the brightness of the
display will change in the below sequence on every press:
Backlight o > Backlight 01 > Backlight 02 > Backlight 03 > Backlight o >……
In Standby mode, switch the display brightness between “Backlight 01” and
“Backlight O” by pressing the BACKLIGHT button.
The display backlight level is defaulted to “Backlight 01” in AC standby and “Backlight
03” during operation. This is resumed only when the factory reset has taken place.
System Reset
There may be times when you need to reset your unit back to the factory settings especially
when you have moved house. If you experience reception problems you may want to reset
and try again. If you move to another part of the country and pick up the local and national
DAB stations in that area, your previously tuned channels may no longer be available.
1. Press and hold the MENU button until the “Press SELECT to conrm reset” shows on
the display.
2. Press the SELECT button to start the system reset, “Restarting…” will show on the
display. After the reset is complete, the unit will go to standby mode.
3. Press the STANDBY button again to turn the unit on, the unit will then start
scanning for DAB channels immediately.
After the system reset, all the tuned stations, DAB & FM preset stations and
alarm settings will be erased.
S2DABB_W11E IB_121121_Michelle.indb 12 21/11/2012 3:37 PM
To Next Page
Loading...
Need help?
General
