User’s Manual Sanli LS42 - LSP42 - LSP46-LBP46 / 17
Air Filter
An air filter in poor condition will reduce
the performance and life of the engine
while making it harder to start. Regular
checks are therefore essential, especially
when using the mower in dusty
conditions. Check and clean the air filter
every 25 hours of use or more often if
the engine is used in a dusty environment.
Remove the air box lid (fig.17) and carefully remove the foam filter
cartridge. Clean the cartridge in a small bowl of warm water containing a
few drops of washing-up liquid until it is perfectly clean and free from all
traces of grease and dust. Rinse the filter cartridge in clean water and then
squeeze gently to remove most of the water. Let it air dry until it is
completely dry.
WARNING: Never clean the foam cartridge in petrol, white spirit or other
solvents. These products will degrade the filter cartridge.
Clean the cover and inside of the air box with a clean lint-free cloth. Apply
a uniform layer of oil to the outside of the cartridge filter with a brush
(you can use clean engine oil for this). Insert the filter cartridge into its
housing and replace the filter lid, ensuring that each component is in
place and properly installed. If the filter cartridge is damaged or is very
dirty, replace it using a genuine SANLI part
WARNING: Do not twist the cartridge to clean foam, as you could damage it.
The SANLI LSP46 mower is equipped with a dual filtration system
comprising of the foam pre-filter and a cartridge filter paper.
The maintenance of the foam pre-filter is identical to that of a foam
cartridge filter, as described above. The cartridge filter paper should be
cleaned with a vacuum cleaner. If it is dirty or contaminated with oil or
petrol, replace it.
Clean the cover and inside of the air box with a clean cloth. Evenly apply a
thin layer of oil to the outside of the cartridge filter with a brush (you can
use clean engine oil for this). Replace the filter cartridge in its housing and
then replace the lid of the air box, ensuring that each component is in
place and properly installed.
To Next Page
Loading...
