PAGE 12
INSTRUCTION MANUAL
TECHNICAL SPECIFICATION
ca
e
b
d
Consistent with our policy of continuous
improvement, SANLI reserves the right
to change the design and conFiguration
of any of its products without notice or
obligation.
and images in this manual as being for
illustrative purposes only. They may not,
in any case, serve as a basis for any legal
claim.
Model
5 5
Engine
Displacement
Maximum pow
Tank capacity
1.0 L
Engine oil capacity
0.6 L
Maximum operating speed
3100 rpm
Cutting width
400 mm
Adjustable cutting heights
7
Cutting height
Grass collection capacity
50 L
Noise level
75 dB
Chassis
Heavy duty steel
Dimensions:
a = 136, b = 102,
(cms)
c = 54, d = 88, e = 56
Problem Likely cause Suggested remedy
Engine does not
start
Throttle lever not set properly Set to ‘Cold Start’ for cold or a little lower when warm
Out, or almost out, of fuel Fill tank with min 95 octane premium unleaded petrol
Spark plug depleted Replace with a suitable new spark plug
Spark plug dirty Clean or replace with a new spark plug
Spark plug not connected
Flooded engine
Turn fuel ‘off’ then pull starter rope until the mower starts, then
turn the fuel on
Old petrol in the tank (older
than 4-6 weeks)
Contact an authorised dealer
Water in the fuel tank Contact an authorised dealer
Engine stops often
Blocked fuel supply Ensure the fuel line is not pinched or blocked
Fuel cap is not venting You may need to slightly loosen the fuel cap
Wrong type of fuel
unleaded petrol
Engine loses power
Incorrect height adjustment Raise the mower’s cutting height lever
Blocked fuel cap vent holes Ensure the 3 holes in the fuel tank cap are clear
Mower vibrates too
much
Loose cutting blade Check and tighten bolts and nuts
Replace disc or blades
Clean and ensure underside clear of build up
Replace blades
Poor cutting or
catching
Reattach carefully and also check for damage
Incorrect cutting height set Adjust the cutting height
Blocked grass catcher vents Clear and clean the vents
To Next Page
Loading...
