Need help?Do you have a question about the SANLI PCS355 and is the answer not in the manual?
Assemble the lower loop handle by attaching bolts and ensuring correct cable placement.
Attach the upper handle using knobs and bolts, carefully routing cables.
Connect the drive cable by positioning the lever correctly and securing it.
Secure the drive cable by installing the cable clip into its designated position.
Mount the grass catcher by lifting the rear flap and hooking it onto the bar.
Add 600ml of SAE30 engine oil before first use and check level before each use.
Fill the tank with min 95 octane unleaded petrol, leaving space for expansion.
Connect the grass catcher by lifting the rear flap and locking it into place.
Adjust cutting height centrally and mow appropriately for best results.
Clean the mower after use, store properly, and prepare for transport by emptying fuel.
Cut lawn in alternative directions at an equal height, slightly overlapping lines.
Check blade, bolts, and shaft for damage or wear before and after mowing.
Have blade edges sharpened and balanced annually by a specialist.
Mount blade with cooling fins towards engine, tighten screws firmly.
Check spark plug after 5 hours, then every 25 hours. Clean or replace as needed.
Clean or replace air filter every 25 hours or more if used in dusty conditions.
Adjust transmission cable tension for proper drive lever movement and function.
Check oil level between min/max marks on dipstick before each use. Add oil if necessary.
Change oil after first 5 hours, then every 25 hours or annually. Warm engine before changing.
Record of initial service after 5 hours of usage.
Record of service after 25 hours or one year.
Record of service after 50 hours or two years.
Record of service after 75 hours or three years.
Record of service after 100 hours or four years.
Record of service after 125 hours or five years.
General| Brand | SANLI |
|---|---|
| Model | PCS355 |
| Category | Lawn Mower |
| Language | English |
To Next Page
