PAGE 8
INSTRUCTION MANUAL
USING YOUR MOWER
ON OFF
Attach the Grass Catcher
The grass catcher attaches easily by
lifting the mower’s Rear Flap with one
hand (Fig. 9) and locking the Grass
Catcher into position (Fig. 10).
Cutting Height Adjustment
!
WARNING!
Turn mower off before
adjusting cutting height lever
For best results adjust the cutting
height of your mower to suit the
mowing conditions (Fig. 11). Do not
try to remove too much grass in one
pass.
Adjustment of the cutting height is
made centrally. Turn off the mower
and take the weight of the mower
by lifting. Take hold of the cut height
adjustment lever, positioned on the
mower’s right hand rear wheel.
Move the lever outwards to release
it from its locating notch. Move
the lever towards the front of the
machine to increase the cutting height
and towards the rear to reduce the
cutting height. Return the lever to
the locating notch to set the desired
cutting height.
securely into its serrated holder.
Mowing your Lawn
Start your mower (see: Starting the
engine).
Fig 9
Fig10
Fig12 Fig13(PCS350S only) Fig14
Fig11
For PCS350S only: To power the
mower forward, move the Drive
Lever up and forward (Fig 13). The
mower can be pushed with the
drive disengaged for more precise
handling.
After mowing and emptying the
Grass Catcher ensure the engine is
turned off.
Cleaning your Mower
!
WARNING!
Turn mower off before
cleaning
Regular cleaning after each use
will ensure better functioning of
the mower and reduce the risk of
corrosion or seizure.
the engine to cool then remove
accumulated grass clippings from
and around the engine with a brush.
Clean the grass collection bag
annually with a brush or gentle spray
of water and allow to dry.
Clean underneath regularly -
disconnect the spark plug cap and tilt
the mower backwards. Remove cut
grass from the cutting system with a
scraper and a brush.
Do not use a pressure washer or hot
water to clean the mower. Dry off the
machine before storing by leaving it
clear surface to prevent corrosion or
seizure.
Storing your Mower
!
WARNING!
Store your mower in a dry,
well-ventilated area, away
sparks or heat sources.
Store your mower in a dry, well-
ventilated area, away from sparks or
heat sources. Disconnect the spark
plug cap. Avoid storing beneath a
tarpaulin or similar cover as it may
cause condensation resulting in
corrosion.
Transporting your Mower
Ensure the fuel tank is empty. Run
the engine until any remaining fuel is
consumed. Allow the engine to cool.
Turn fuel tap to OFF position (Fig. 14 ).
How to cut for best results
For best results cut your lawn in
alternative directions switching
direction each time you cut. Cut your
lawn at an equal and same height.
Slightly overlap your cutting lines.
To Next Page
Loading...
