Need help?Do you have a question about the Sansui AU-X711 and is the answer not in the manual?
General| Power Output | 90 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency Response | DC to 300kHz (±3 dB) |
| Damping Factor | 100 |
| Input Sensitivity (Line) | 150 mV |
| Signal-to-Noise Ratio | 100 dB |
| Dimensions | 430 x 152 x 403mm |
| Weight | 13.2kg |
| Channel separation | 70 dB |
| Input sensitivity | 2.5mV (MM), 250mV (line) |
| Signal to noise ratio | 85dB (MM), 110dB (line) |
| Speaker load impedance | 4Ω - 16Ω |
Details RMS and DIN power output into different impedances.
Lists frequency response and input levels/impedances.
Details SNR for inputs and control frequency responses.
Specifies power consumption, physical dimensions, and unit weight.
Illustrates signal paths for EQ, Tone Control, Amplifier, and Power Amp sections.
Adjusts HOT/GND and HOT/COLD balance on the driver amplifier board.
Adjusts HOT/COLD balance on the flat amplifier board.
Adjusts bias current for HOT and COLD amplifier sections.
Provides the schematic for the EQ and Control Amplifier sections.
Details the schematic for the Power Amplifier and Power Supply sections.
Provides instructions for replacing major components like the driver amp board and front panel.
To Next Page
