EasyManua.ls Logo

Sansui LCDWDVD320 - Setting the V-Chip

Sansui LCDWDVD320
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
Press or to display the
password entering mode.
Setting the V-Chip
Press or to select
(LOCKS) menu.
Enter the password (4 digits)
using Number buttons (0-9),
then press ENTER.
To register password
An age limitation can be set to restrict children from viewing or hearing violent scenes or picture that
you may choose to exclude. The restriction applies to “TV RATING” and “MOVIE RATING” if this data is
transmitted. You may set this restriction separately. To use the V-Chip function, you must register a
password.
NOTES:
If you forget the password, contact
Customer Service at 1-800-289-0980
for assistance. Your original remote
control will be required.
To avoid forgetting the password, write
it down and keep in the safe place.
2
3
4
” appears instead of the number.
LOCKS
NEW PASSWORD
SELECT : [0-9] ENTER : SET
EXIT : END
LOCKS
NEW PASSWORD
SELECT : [0-9] ENTER : SET
EXIT : END
LOCKS
V-CHIP SET
NEW PASSWORD
:SELECT :ADJUST
Press SETUP/TV MENU in the TV mode.
The TV menu screen will appear.
1
Enter the same password
again for safety
,
then press
ENTER.
The password is now
registered and the V-Chip
menu will appear on the
screen.
5
LOCKS
CONFIRM PASSWORD
SELECT : [0-9] ENTER : SET
EXIT : END
5V10101A[EN] P19-21 9/30/05, 15:0919

Table of Contents

Related product manuals