Santint
M3 Manual Dispenser V1.0 3
4. Installation and Preparations before Operation
4.1 Installation
Please refer to Installation Guide.
4.2 Preparation before operation
A The colorant in each can must be fully mixed (It is not recommended to be mixed by shaker as too
many bubbles may appear that would cause the chromatic aberration).
B Remove each canister lid and pour the colorant into the corresponding canister.
C Before operation, remove the air out of each pump. Follow the procedures:
a Press down the black button and lift the black gauge. Align the maximum value of the gauge
with the upper surface of the handle, and then release the black button. Lift the handle to its
highest position and press down it slowly. Do not touch the valve key during this process. Repeat
the foregoing operation for 5-6 times.
Press down the red button and lift the red gauge. Align the maximum value of the gauge with the
upper surface of the handle, and then release the red button. Lift the handle to its highest position
and press down it slowly. Do not touch the valve key during this process. Repeat the foregoing
operation for 5-6 times.
b Open the tray by pulling it down. See Figure 2. Move the tray up and down to an appropriate
height. Press it gently so that it can be locked into the grooves of the location plate. See Figure 3.
(Return the tray back to its original position when it is not in use)
To Next Page
Loading...
