Santint M3 - Maintenance; Daily Maintenance; Weekly Maintenance; Periodical Maintenance

Santint
M3 Manual Dispenser V1.0 7
(Repeat the foregoing step if one colorant is required for several times)
Notice: the gauge is precision tool, do not drop the red/black gauge when reset it back to its zero
position to keep its accuracy.
Notice: reset the gauge to the zero position when not using it.
The red gauge volume plus the black gauge volume shall equate to the formula volume of the
colorant.
G．Repeat the foregoing steps for the next colorant.
6. Maintenance
6.1 Daily Maintenance
A. Move each plunger handle up and down three times every day to ensure smooth flow of the
colorant and to avoid blockages in pumps and canisters.
B. Clean the nozzle with soft cloth or cotton moistened with water or thinner to keep it
unobstructed.
C. Move the valve handle 5 times every day. This can keep the valve in optimum working condition
and prevent the colorant from drying in the valve.
D. Check the colorant level in canisters and refill if necessary. If the colorant is lower than the
feeding level, air will enter the pump when lifting up the plunger handle. This will cause
inaccuracy in dispensing.
6.2 Weekly Maintenance
A. Check if the canister is loose. If so, tighten the fixing screws under the turntable (see
Replacement of Canister)
B. Check if the gauge’s scales are damaged or covered with colorant. Clean or replace the gauges if
necessary.
6.3 Periodical Maintenance
The dispenser must be maintained every 3-6 months for the following aspects:
A Check the fixed base is loosed or not (Figure a)，If loosed, push the base to the most bottom
position, fasten two screws of the base Symmetrically with inner hexagon Spanner. (Figure b，