To Next PageTo Next Page
Need help?Do you have a question about the Santon AH10/2.2 and is the answer not in the manual?
General| Capacity | 10 liters |
|---|---|
| Power | 2.2 kW |
| Voltage | 230 V |
| Protection | IP24 |
| Heating Element | Copper |
| Thermostat | Adjustable |
This water heater must only be installed by qualified persons.
Guidance on safe use by children and persons with reduced capabilities, emphasizing supervision.
Specifies electrical rating, capacities, weight, rated pressure, and minimum inlet pressure.
Details storage volume, mixed water, energy efficiency, and annual consumption for different models.
Instructs to switch off electricity immediately if water flows from the relief valve and contact service.
Mandates fitting of a Pressure (Expansion) Relief Valve, detailing expansion conditions and accessory packs.
Details on earthing, supply type, competent electrician requirement, and wire colour coding.
Illustrates the mains supply connection, double pole isolating switch, and element wiring.
Details steps to fill the unit, check for leaks, test relief valves, and switch on the electrical supply.
Steps for draining the water heater and removing scale from internal components.
Identifies possible causes like electrical faults, thermal cut-out, or thermostat issues.
Addresses continuous or intermittent discharge due to pressure or expansion issues.
