Santon PP210E User Manual

1
UNVENTED MAINS PRESSURE WATER HEATER
100, 120, 150, 170, 210, 250 AND 300 LITRE
DIRECT AND INDIRECT MODELS
INSTALLATION AND SERVICING INSTRUCTIONS
36 00 5803 Issue 7
PACK CONTENTS
Premier Plus unvented water heater incorporating immersion heater(s) and thermal controls
Factory tted Temperature/Pressure Relief Valve Cold Water Combination Valve Expansion
Vessel Expansion Vessel Mounting Bracket Tundish Motorised Valve (Indirect models
only) Compression nuts and olives Immersion heater spanner Installation Instructions

Santon PP210E Specifications

General

Brand	Santon
Model	PP210E
Category	Water Heater
Language	English

Summary

1.0 INTRODUCTION

1.0 INTRODUCTION

Provides an overview of the Santon Premier Plus water heater.

2.0 GENERAL REQUIREMENTS

2.1 COMPONENTS SUPPLIED

Lists all items included with the Premier Plus water heater unit.

2.2 SITING THE UNIT

Guidance on the correct placement and location for the unit.

2.3 WATER SUPPLY

Specifies requirements for the incoming mains water supply.

2.4 OUTLET/TERMINAL FITTINGS

Discusses compatible outlet fittings and system pressure.

2.5 LIMITATIONS

Details conditions or equipment not suitable for use with the heater.

3.0 INSTALLATION – GENERAL

3.2 COLD FEED

Recommendations for the cold water supply pipe.

3.3 COLD WATER COMBINATION VALVE

Describes the combination valve and its installation.

3.5 EXPANSION VESSEL

Details the function and installation of the expansion vessel.

3.8 DISCHARGE PIPEWORK

Requirements for safe discharge pipework installation as per Building Regulation G3.

3.9 WARNINGS

Crucial safety warnings pertaining to the installation process.

4.0 INSTALLATION - DIRECT UNITS

4.1 PLUMBING CONNECTIONS

Plumbing connections required for direct units.

4.2 ELECTRICAL SUPPLY

Electrical connection requirements for direct units.

5.0 INSTALLATION - INDIRECT UNITS

5.1 PLUMBING CONNECTIONS

Plumbing connections required for indirect units.

5.2 ELECTRICAL SUPPLY

Electrical connection requirements for indirect units.

6.0 COMMISSIONING

6.1 FILLING THE UNIT WITH WATER

Step-by-step guide for filling the unit with water.

6.2 SYSTEM CHECKS

Essential checks to perform after filling the unit.

6.3 DIRECT UNITS

Commissioning steps specific to direct unit models.

6.4 INDIRECT UNITS

Commissioning steps specific to indirect unit models.

7.0 MAINTENANCE

7.1 MAINTENANCE REQUIREMENTS

General requirements and frequency for system maintenance.

7.2 SAFETY VALVE OPERATION

Procedure for testing the safety valves.

7.5 EXPANSION VESSEL CHARGE PRESSURE

How to check and recharge the expansion vessel's pressure.

8.0 FAULT FINDING AND SERVICING

8.1 IMPORTANT

Crucial notes and safety precautions for servicing personnel.

8.2 SPARE PARTS

A list of available spare parts with part numbers.

8.3 FAULT FINDING

Detailed chart for identifying and rectifying operational faults.

9.0 USER INSTRUCTIONS

9.1 WARNINGS

Essential safety warnings for users of the system.

9.2 TEMPERATURE CONTROLS – DIRECT UNIT

Instructions on adjusting temperature settings for direct units.

9.3 TEMPERATURE CONTROLS – INDIRECT UNITS

Instructions on adjusting temperature settings for indirect units.

10.0 GUARANTEE

ENVIRONMENTAL INFORMATION

11.0 SPARES STOCKISTS