EasyManua.ls Logo

Santon PP150E User Manual

Default Icon
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
UNVENTED MAINS PRESSURE WATER HEATER
100, 120, 150, 170, 210, 250 AND 300 LITRE
DIRECT AND INDIRECT MODELS
INSTALLATION AND SERVICING INSTRUCTIONS
36 00 5803 Issue 7
PACK CONTENTS
Premier Plus unvented water heater incorporating immersion heater(s) and thermal controls
Factory tted Temperature/Pressure Relief Valve Cold Water Combination Valve Expansion
Vessel Expansion Vessel Mounting Bracket Tundish Motorised Valve (Indirect models
only) Compression nuts and olives Immersion heater spanner Installation Instructions
Question and Answer IconNeed help?

Do you have a question about the Santon PP150E and is the answer not in the manual?

Santon PP150E Specifications

General IconGeneral
BrandSanton
ModelPP150E
CategoryWater Heater
LanguageEnglish

Summary

1.0 Introduction

2.0 General Requirements

2.1 Components Supplied

Lists all components included with the water heater unit.

2.2 Siting the Unit

Provides guidelines on the correct placement and location for the water heater.

2.3 Water Supply

Details requirements and recommendations for the mains water supply.

3.0 Installation - General

3.1 Pipe Fittings

Specifies the types of pipe fittings required for connecting to the unit.

3.3 Cold Water Combination Valve

Explains the installation and function of the combination valve.

3.5 Expansion Vessel

Describes the expansion vessel and its connection requirements.

4.0 Installation - Direct Units

4.2 Electrical Supply

Details electrical connections and safety for direct units.

4.3 Safety

Crucial safety warnings related to direct unit installation.

5.0 Installation – Indirect Units

5.2 Electrical Supply

Details electrical connections and safety for indirect units.

5.4 Primary Circuit Control

Explains controls for the primary circuit in indirect systems.

5.3 Boiler Selection

Guidance on selecting a compatible boiler for indirect systems.

6.0 Commissioning

6.1 Filling the Unit with Water

Step-by-step guide to filling the unit with water.

6.2 System Checks

Procedures for checking all connections and valves after filling.

6.3 Direct Unit Commissioning

Commissioning steps specific to direct heating units.

6.4 Indirect Unit Commissioning

Commissioning steps specific to indirect heating units.

7.0 Maintenance

7.2 Safety Valve Operation

Procedures for checking safety valves.

7.5 Expansion Vessel Charge Pressure

How to check and recharge the expansion vessel.

8.0 Fault Finding and Servicing

8.1 Important Safety Notes

Key safety and procedural notes before servicing.

8.2 Spare Parts

Lists available spare parts and their part numbers.

9.0 User Instructions

9.1 User Warnings

Critical warnings for users regarding system faults.

9.2 Temperature Controls – Direct Unit

How to adjust temperature controls on direct units.

9.3 Temperature Controls – Indirect Units

How to adjust temperature controls on indirect units.

10.0 Guarantee

10.0 Environmental Information

11.0 Spares Stockists

Related product manuals