Sanus BSF316 - Position Template and Drill Holes; Remove Wall Plate Covers

11
2X
2X
2 ¾ in. (7.0 cm)
1/8 in.
(3 mm)
Drill two holes using a 1/8 in. (3 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth
of 2 ¾ in. (7.0 cm).
5
DRILL
CAUTION:
Be sure you drill into the
CENTER of the stud.
05
6
REMOVE COVERS
06
Remove wall plate covers
P
from arm assembly
06
.
P
P
Wood Stud Installation
TIP:
To calculate your precise wall plate location,
check out our HeightFinder at sanus.com
[www.sanus.com/1172].
sanus.com
/1172
HeightFinder™
Visit
4
POSITION TEMPLATE
Position drill template
05
at your desired height. Level
and mark the hole locations in the stud center.