STRINGING OF DIAL ROPE (RECEIVER UNIT) ___________________ _
(
l
)
\....,,I
(1) Preparation
Prepare
0.5mm<P
x
1500mm
rope.
Knot
an
one
end
of
this
rope
so
that
the
inner
diameter
of
thus
formed
loop
becomes 5¢mm. Bind another end of rope to the spring coil so that the overall length becomes 1006mm.
--1~-----1006 mm--------
(2) As shown in illustration, hook the 1.O.5,pmrn loop to the (3)
drum. String the free end of r~ in the direction of
G) , and advance stringing form
~
to G) and then to
® . At @ , coil the r~ round ® ,fq three turns,
and string through @ , lJ__) , @ and~ . Then coil
a~nd the drum for one turns in order of @ and
'2.!) . Next, fasten the spring coil to the drum.
Finally, stretch thus strung rope to pass through @.
3 turns
~
Bia
R
-2-
Adjustment of pointer position
Agree the center of pointer LED with the vertical
posisition of marked on the front panel.
Adj.
FM 188 I
I I I
..'iI:!11__ METER
~
sw, 2.3
MW 540
Tuner PCB
To Next Page
Loading...
