1
Connect DVD Player or similar digital equipment’s
Component Video Out to the DTV’s Video VIDEO3
jacks.
2
Connect DVD Player or similar digital equipment’s
Audio Out to the DTV’s VIDEO3 Audio jacks.
3
Press POWER to turn on the DTV, then turn on
external equipment.
4
Press INPUT to select
Video 3
to view the DVD
program.
The Component Video jacks will accept HDTV, EDTV, or
SDTV video content.
Switch off DTV and external equipment before connect-
ing cables.
(Cables are not supplied.)
Follow these steps
to easily connect your STB or DVD Player to this DTV:
DVD PLAYER
(or similar digital
device such as a
Digital Satellite
Receiver.)
COMPONENT JACKS
1
What you will need
for connections:
Component Video Cable – 1
Audio Cable – 1
VIDEO2 and VIDEO3 jacks have identical functions. Com-
patible video devices can be connected to either set of
jacks.
Press the INPUT key after connecting the cables, to select
the
Video 2
or
Video 3
input signal. There is NO need to tune
to a blank channel.
“
No Signal” will appear randomly on the screen when no
signal is detected at the VIDEO2 or VIDEO3 inputs.
2
REMOTE CONTROL
4
3
USING COMPONENT JACKS TO CONNECT A DVD PLAYER
OR OTHER DIGITAL EQUIPMENT
13
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
1
2
DTV BACK
SIGNAL CONVERSION CHART
INPUT SIGNAL
(From external equipment)
OUTPUT SIGNAL
(Display)
480i 720p
480p 720p
1080i 720p
To Next Page
Loading...
