ANALOG AV CONNECTIONS
Switch off DTV and external equipment before connect-
ing cables.
(Cables are not supplied.)
BACK VIEW
OF VCR
DTV AV
INPUT
JACKS
1
Connect VCR’s Audio Video Out to the DTV’s
VIDEO1 jacks.
NOTE: For Mono VCR (Single Audio Jack), connect VCR
Audio Out to DTV Audio (L) Input.
22
Optional
Connect VCR’s S-Video Out to the HDTV's S-Video In
Jack.
NOTE: S-Video jack connections override VIDEO1 Video
jack connection.
3
Press POWER to turn on the DTV, then turn on exter-
nal equipment.
4
Press INPUT to select
Video 1
to
view the VCR program.
What you will need for connections:
Audio Video Cable – 1
S-Video Cable – 1
S-VIDEO
JACK
22
1
Press the INPUT key after connecting cables to access the
Video 1 input. There is NO need to tune to a blank channel.
“No Signal” will appear randomly on the screen when no
signal is detected at the VIDEO1 video jack.
REMOTE CONTROL
4
3
USING THE ANALOG VIDEO1 JACKS
TO CONNECT A VCR (OR OTHER
ANALOG DEVICE)
14
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
Video 1
NOTES: Don’t be fooled by the phrase
“Available in High-Definition.”
Composite jacks offer only 480i
(SDTV) resolution.
To view available High-Definition
(HD) programs, you must connect
your HD equipment to the Compo-
nent or HDMI jacks.
To Next Page
Loading...
